Machine's Safety Equipment - Husqvarna 128C Manuel D'utilisation

GENERAL SAFETY PRECAUTIONS
CLOTHING
Wear clothes made of a strong fabric and
avoid loose clothing that can catch on
shrubs and branches. Always wear heavy,
long pants. Do not wear jewelry, shorts
sandals or go barefoot. Secure hair so it is
above shoulder level.
FIRST AID KIT
A first aid kit should be carried by opera-
tors of clearing saws, brushcutters or trim-
mers.

Machine's safety equipment

This section describes the machine's safe-
ty equipment, its purpose, and how checks
and maintenance should be carried out to
ensure that it operates correctly. See the
"What is what" section to locate where this
equipment is positioned on your machine.
The life span of the machine can be re-
duced and the risk of accidents can in-
crease if machine maintenance is not car-
ried out correctly and if service and/or re-
pairs are not carried out professionally. If
you need further information please contact
your nearest service workshop.
IMPORTANT! All servicing and repair work
on the machine requires special training. This
is especially true of the machine's safety
equipment. If your machine fails any of the
checks described below you must contact
your service agent. When you buy any of our
products we guarantee the availability of pro-
fessional repairs and service. If the retailer
who sells your machine is not a servicing
dealer, ask him for the address of your near-
est service agent.
WARNING:
that has faulty safety equipment!
Follow the control, maintenance
and service instructions described
in this section. If your machine fails
any of these checks contact your
service agent to get it repaired.
Throttle lock- -out
The throttle lock- -out is designed to prevent
accidental operation of the throttle control.
When you press the lock- -out (A) (i.e. when
you grasp the handle) it releases the
throttle control (B). When you release the
handle, the throttle control and the throttle
lock- -out both move back to their original
positions. This movement is controlled by
two independent return springs. This ar-
rangement means that the throttle control is
automatically locked at the idle setting.
Never use a machine
A
Make sure the throttle control is locked at
the idle setting when the throttle lock- -out is
released.
Press the throttle lock- -out and make sure it
returns to its original position when you re-
lease it.
Check that the throttle control and throttle
lock- -out move freely and that the return
springs work properly.
See instructions under the heading Start.
Start the machine and apply full throttle.
Release the throttle and check that the
cutting attachment stops and remains at a
standstill. If the cutting attachment rotates
with the throttle in the idle position then the
carburettor idle setting must be checked.
See instructions under the heading
Maintenance.
6
B