Installation Procedure - Toto GR TLG02201U Manuel D'installation Et D'utilisation

Valves
1. Thread a mounting nut to the bottom
of the valve. Place a washer and gasket as
shown.
NOTE: the hot water valve has a red
marking on side of body.
2. Pass the valve up through the
installation hole.
Insert the gasket and fasten the collar to
the valve body until it stops.
3. Fixate the valve by threading the
mounting nut up the valve until hand
tight. Tighten the retaining screws equally
to secure.
Do not overtighten!
4. Repeat steps 1-3 for remaining valve.
NOTE: Hoses to connect valve inlets to
water supply lines not included.
Spout
5. Pass the supply hoses and
mounting stud through the
mounting hole until the spout
comes to rest.

INSTALLATION PROCEDURE

4
Gasket
(Rubber)
Washer
(Metal)
Mounting
Nut
Collar
Form Gasket
Valve Body
Mounting
Screws
Spout
Gasket
(Rubber)