Toto GR TLG02201U Manuel D'installation Et D'utilisation page 6

9. Insert the drain lift rod through
the opening in the spout.
Drain
10. Remove the plunger, flange and gasket
from the drain assembly by unfastening
the flange and pulling these parts from the
drain.
Insert the drain body up through
the drain hole from below the
lavatory. If necessary, turn the
nut and push the washer and
gasket (thick) down to allow for
clearance.
While holding the drain body in
place, fasten the flange to the
drain body from the top. Ensure
that the gasket (flat) is between
the flange and the lavatory as
shown. Once the flange is fully
seated, turn the nut below the
lavatory up until a good seal is
formed. Do not overtighten!
Reinsert the plunger if needed.
INSTALLATION PROCEDURE
Gasket (thick)
6
Plunger
Flange
Gasket
Washer
Nut
Body
Tailpiece
Plunger Hole
Lever Hole
Bushings
Short End Long End
Drain Lift
Rod
Lever Hole
Pivot Ball Nut
Pivot Arm