Control Panel And Features - Amana NFW5800HW Guide D'utilisation Et D'entretien

CONTROL PANEL AND FEATURES

NOTES:
Not all features and cycles are on all models.
■
If your model has a touch interface, the control panel features a sensitive surface that responds to a light touch of your finger. To
■
ensure your selections are registered, touch the control panel with your fingertip, not your fingernail. When selecting a setting or
option, simply touch its name.
If your model has physical buttons, make sure to press the button firmly.
■
At cycle completion, your setting and option choices will be remembered for the next cycle. However, if power to the washer is
■
lost, the settings and options will go back to the factory defaults.
1
4
POWER
1
Select to turn the washer on and off. Select to stop/cancel
a cycle at any time.
CYCLES
2
At each stage of the process, you may notice sounds or
pauses that are different from traditional washers.
Press to select a cycle for your load.
START/PAUSE
3
Touch and hold for 3 seconds until the light above START/
PAUSE comes on to start a cycle, or touch once while a
cycle is in process to pause it.
CYCLE STATUS DISPLAY
4
The CYCLE STATUS DISPLAY shows the progress of a cycle.
At each stage of the process, you may notice sounds
or pauses that are different from traditional washers.
Estimated Time Remaining
The Estimated Time Remaining shows the time required
for the cycle to complete. Factors such as load size,
2
Cycles
Hold 3 sec for
Control Lock
6
Cycles and settings vary by model.
modifiers, options selected, and water pressure may affect the
time shown in the display. Tightly packed loads, unbalanced
loads, or excessive suds may cause the washer to lengthen
the cycle time as well.
Sensing
When START/PAUSE is touched the washer will chime,
indicating it is starting, and "Sensing" will display. The drum
will make a partial turn. The door will click one more time
when it locks.
Once the door has locked, the washer will start.
This sensing process will continue throughout the cycle. After
the load is sensed, the estimated time based on load size will
be displayed and water will be added. You may hear water
flowing through the dispenser, adding detergent to the load.
The actual cycle time may be lengthened; however, the
display will continue to show the estimated time.
In the display, "Sensing" may blink once a second at various
times during the cycle, such as when the washer is reducing
extra suds.
3
5
5