Control Panel And Features - Amana NTC3500FW Guide D'utilisation Et D'entretien

Control Panel and Features

LED TIME/STATUS DISPLAY
1
The Remaining Time display shows the time required for
the cycle to complete. Factors such as load size and water
pressure may affect the time shown in the display. Tightly
packed loads, unbalanced loads, or excessive suds may
cause the washer to adjust the cycle time as well.
2 LID LOCK LIGHT
The Lid Lock indicator lights up when the lid is locked and
cannot be opened. If you need to open the lid, press and
hold START/PAUSE. The lid will unlock once the washer
movement has stopped. This may take several minutes if
the load was spinning at high speed. Press the Start/Pause
button again to restart the cycle.
START/PAUSE
3
After selecting a wash cycle, press START/PAUSE to start
the cycle. Press once to pause a cycle. The flashing lights
indicate the selected cycle and the current process.
4
CYCLE TIME (+ or -)
Press "+" or "-" to adjust the duration of a wash cycle.
■
Press "+" or "-" to adjust the duration of a spin cycle.
■
LED display will show the time remaining for the cycle
■
to complete.
If an out-of-range adjustment is made, a buzzer
■
will sound.
End-of-Cycle Signal
Press and hold the plus (+) button for 3 seconds
to enable or disable the end-of-cycle signal.
1
4 5 4
5
6
7
8
2 3
7
6
8
CYCLE
Press CYCLE to select a wash cycle. Choose from Normal,
Delicate, Heavy, Rinse, Spin, or Clean Washer.
NOTE: The washer will remember the last cycle used, with
a default load size of Medium.
LOAD SIZE
Press to select the water level based on the amount of
garments to wash.
When the Medium water level is selected with the Normal
or Heavy cycle, the washer will sense the size of the load
and adjust if required.
TEMP
Select a wash temperature based on the type of fabric
and soils being washed. For best results and following
the garment label instructions, use the warmest wash
water safe for your fabric.
For Portable Installations: If desired, you can change the
water temperature for the rinse cycle by adjusting the Hot
and Cold water faucets. Keep the temperature setting on
your washer set at COLD.
CONTROL LOCK
Press and hold TEMP for 4 seconds to lock the controls.
Press and hold for 4 seconds to unlock. You may still press
POWER ON/OFF to turn off the washer.
POWER ON/OFF
Press POWER ON/OFF to turn on or off the washer.
Press once while a cycle is running to stop the washer.
13