Amana NFW5800HW Guide D'utilisation Et D'entretien page 18

TROUBLESHOOTING
(in Canada www.amanacanada.ca) for assistance and to possibly avoid a service call.
If you experience
Error Code Appears in Display (for 2- and 3-digit displays) (cont.)
"rL" (remove load) appears
in display
Loc
F# E# or F## E## code
other than as described
above appears in display
Washer making error
beeps
Washer beeps when Start/
Pause is touched
CL appears on display, or
Clean Washer LED flashing
at end of wash cycle (on
some models)
Washer won't start
"PF"
F0 E5 or "ob"
"dr" or F5 E4
18
First try the solutions suggested here or visit our website at www.amana.com
Possible Causes
Load detected in drum during Clean
Washer with affresh cycle.
®
Control is locked.
System error code.
Door has not been opened and
closed for at least three cycles.
Door not closed.
The washer has run 30 wash cycles
and is indicating a reminder to run the
Clean Washer with affresh
Control lock could be enabled.
Appears upon recovery from power
loss, if power was lost while running
a cycle.
Off balance load detected. This
means that your washer detected an
off balance load and that caused the
cycle to take longer than usual or the
clothes to be more wet than usual.
Door not opened between cycles.
Remove items from washer drum and restart Clean Washer
with affresh
®
This is not an error code but just an indication that the
control is locked. Press and hold the control lock key for
three seconds to unlock.
Touch POWER once to clear the code. Then touch POWER
again and restart the washer. If code appears again, call for
service. Unplug washer for 30 seconds; then plug back in.
This code may occur when the washer is first turned on.
Open and close the door to clear the display.
Close the door completely.
Run the Clean Washer with affresh
with affresh cycle is not turned on, the LED will stop flashing
®
cycle. at the end of a wash cycle after running three more regular
®
wash cycles. After 30 more wash cycles are completed, the
Clean Washer with affresh
a wash cycle as a reminder.
To check whether the unit is in control lock, try powering On
the unit. On doing that if you see the code 'Loc' displayed
in the seven segment display, then you know that control is
locked. To unlock controls press and hold the 'control lock'
key for three seconds.
Be sure the door is closed.
Make sure you press and hold the start button for 1 full second.
Make sure the door has been opened and closed since the last
cycle was run.
Touch POWER once to clear the code. Then touch POWER
again and restart the washer.
Touch POWER once to clear the code. Then touch POWER
again and restart the washer.
Open and close the door. Touch POWER once to clear the
code. Then touch POWER again and restart the washer.
Solution
cycle.
cycle. If the Clean Washer
®
LED will again flash at the end of
®