Speaker Output Levels; Before You Begin - Yamaha DSP-AX1 Mode D'emploi

This section explains how to set the speaker output levels using the test tone generator. The Dolby Surround test is for balancing the output
levels of the six speakers required for surround sound systems. The DSP test is for balancing the Front Effect speakers with the Main
speakers for the DSP sound field programs.

Before You Begin

BASS TREBLE
0 0
1 1 1 1
2 2 2 2
3 3 3 3
4 4 4 4
– + – +
5 5 5 5
PARAMETER
SET MENU
10KEY DSP

Speaker Output Levels

BALANCE 1
1
0
1 1
2 2
3 3
4 4
L 5 5 R
2
2
3
3
4
4
• Select "TEST DOLBY SUR." to match the output levels of the Center, Rear
• Select "TEST DSP" to match the output levels of the Front Effect speakers
Set BASS, TREBLE and BALANCE on the front panel to "0" (the
center position) and turn off BASS EXTENSION.
Sit in the main listening position and set PARAMETER/SET
MENU on the remote control to PARAMETER.
Set 10KEY/DSP on the remote control to DSP and press
SUR.
Press TEST on the remote control once or twice to select the test
you want.
Center and left and right Rear speakers to the left and right Main speakers.
to the Main speakers.
/ DTS
27