Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
10
VIDEO
Press OK to select VIDEO ; the test light in the
front of the camera will flash for 60 seconds to
Video
allow the operator to walk away from the camera
without being recorded.
T
TEST
To set the camera and the desired distance, select
TEST mode. No picture or video will be recorded.
Test
Walk in front of the camera. When the camera
detects movement, the light flashes to indicate that normally,
a photo or video would have been recorded. If the system does
not detect the movement, increase the distance detection using
the dial DISTANCE or realign the system differently. Once
you understand how the device responds to detections, you can
better adjust the direction or the height of the camera.
In TEST mode, it is possible to take a picture by pressing
the OK button. The photo is saved and appears in the
VIEW mode.
How to properly install your camera
using the supplied installation strap:
(Recommended installation height: about 3 feet).
Test light
Settings
11
Publicité
Table des Matières
