Installation Instructions - Zehnder ComfoConnect Splitter 5x 0-10V Manuel D'installation

3. Installation instructions

Install the ComfoConnect Splitter
5x 0-10V as close as possible to
the ventilation unit.
Do not install the ComfoConnect
Splitter 5x 0-10V in a room with
condensation.
Incorrect connection can damage
the device.
Only use correct tools and
installation material to install the
ComfoConnect Splitter 5x 0-10V.
Use the GND, 0-10V IN and 12V
connections to connect the CO
Sensors 0-10V. Connect up to five
CO Sensors (to the inputs IN 1 to
2
IN 5).
When connecting to the
ventilation unit, use only the
GND connection and 0-10V OUT
connection.
Connect the CO
ventilation unit using a solid cable
with a diameter of at least 0.6mm.
Do not use an extension cable
between the ComfoConnect
Splitter 5x 0-10V and the wall
socket.
Connect no more than one CO
Sensor per single connector of
the ComfoConnect Splitter 5x
0-10V.
EN 14
2
Sensors and
2
2
Never connect multiple
ComfoConnect Splitters 5x
0-10V to each other. Connect a
maximum of one ComfoConnect
Splitter 5x 0-10V to an analogue
input of a ventilation unit.
(ComfoAir Q with Option Box has
4 analogue inputs that can be
used.)
The ComfoConnect Splitter 5x
0-10 V delivers a maximum power
of 50 mA at 12 V per connected
CO Sensor.
2