Technical Problem - Novy Mini Pure'line 810 Mode D'emploi Et D'installation

Change in colour temperature with LED-lighting
First make sure that the power supply of the hood has
been disconnected. Remove the plug from the hood or
switch off the power group.
The colour of the LED-lighting has been set to 2.700 K
(warm white) by default. If the colour is to be changed
to 4.000 K (neutral white), follow the instruction given
below:
• Open the bottom plate at the bottom of the hood.
• Press with two hands against the side of the inox
lamp holder and carefully pull down simultaneously,
so you get access to the lighting on the inside.
• The wiring has been connected to the LED-lamp
with a connector.
• Disconnect the connector from the LED-lamp and
move the wiring to the other free connection on the
lamp.
• Repeat this for all four LED-lamps.
• Then close the inox lamp holder again.
The colour of the LED-lighting has now been changed
from 2.700 K to 4.000 K.

4.5 Technical problem

In case of technical problems please contact Novy
Service Department:
• Belgium: Tel.: 056/36.51.02
• France: Tel.: 03.20.94.06.62
• Germany: Tel.: 0511.54.20.771
For all other countries: your local installor or Novy Bel-
gium: +32 (0)56/36.51.02
Please supply us with the model number of your
hood. The model number can be found on the
engraved plaque behind the filter.
You can make a note of the number here:
....................................................................................
Dimensions: p. 22-23
Electrical scheme: p. 24
Characteristics of the product on condition of changes
or printing errors, September 2017
EN 21