Maintenance Of The Hood; Led Lighting - Novy Mini Pure'line 810 Mode D'emploi Et D'installation

hood for 5 seconds until the third green LED flashes
3 times.
• The run-out time has been set to 10 minutes (instead
of 30 minutes). The cleaning indicator for recircula-
tion is off.
Cleaning indication
Indication: red indicator lamp lights up
The red indicator lamp will light up after 200 working
hours (time to regenerate the Monoblock recirculation
filter). Refer to the manual of your recirculation kit for
removing and putting back the monoblock filter.
Regenerate the Monoblock recirculation filter
• The Monoblock can be regenerated up to 12 times.
This is done in the oven.
• Place the filter in the oven for 1 hour at 120°C. Pro-
vide sufficient fresh air in the room where the oven
has been placed, as smells can be released. Smells
can be released when baking certain kinds of fish.
In this case it is best to immediately regenerate the
filter in the oven.
Reset the Monoblock recirculation filter
The cooker hood (motor) must be running
Simultaneously press + and – for 5 sec. until the red
indicator lamp flashes 3 times for confirmation. If the
programming is not carried out, the programming is
automatically set after the chimney hood has been
switched on 10 times.
After a reset, the cleaning indication will be set to 200
hours.
Place the Monoblock recirculation filter
Refer to the manual of your recirculation kit for remov-
ing and putting back the monoblock filter.

4.3 Maintenance of the hood

Please allow the lights to cool down sufficiently before
cleaning the hood. Use a soft, wet cloth and a mild
detergent to clean the hood.
Never use aggressive, abrasive detergents or
sponges. Bleach will damage stainless steel.
The stainless steel surfaces can be treated with Novy
Inoxcleaner (906.060) after cleaning.

4.4 Led lighting

Replacing the led lighting
First, remove the power supply from the hood and al-
low
the lighting to cool down sufficiently.
1. Carefully press the spotlight holder; next, remove the
spotlight holder by means of a tilting movement.
2. Removing the LED lamp:
A. First disconnect the cable to the LED to be re-
placed. Disconnect by means of releasing the
lock, by applying light pressure while at the same
time pulling away.
B. Next, remove the LED to be replaced by making a
gentle rotating movement to the left.
3. Mounting the new LED:
A. Place the new LED light into the locking ring.
B. Make a rotating movement to the right until the
LED light is locked.
C. Connect the power cable.
D. Place the spotlight holder back in the cooker
hood and reconnect the power.
EN 20