Technical Problem - Novy Touch 894 Mode D'emploi Et D'installation

• If needed turn the light out withe a quarter turn to take
it out of its support.
• Turn the starter with a quarter turn to take it out.
• Place the new starter in its support and turn with a
quarter turn.
• The starter is installed correctly when you here a soft
clicking sound.
• Place the remplacement lamp in the support and turn
this with a quarter turn until you here a soft clicking
sound.
• alle models have 2 starters from the type: OSRAM St
111 / Novy reference 804-016
Back to the start initial position
• Tighten everything again to the initial position.
• IMPORTANT! When the glass panel (A) is placed
back, the glass panel has to be pushed over the
filterholder so its fixed (fig. 3.3).
• Place the greasse filter back in its support
• Install the cover plate, don't forget to slide de
adjustements clips over the plugs and tighten the
cover plate again.
• The unit is ready for installation.

4.5 Technical problem

In case of technical problems please contact Novy
Service Department:
• For Belgium: Tel.: 056/36.51.02
• For France: Tel.: 03.20.94.06.62
• For Germany: Tel.: 0511.54.20.771
For all other countries: your local installor or Novy Bel-
gium: +32 (0)56/36.51.02
Please supply us with the model number of your hood.
The model number can be found on the engra-
ved plaque behind the filter.
You can make a note of the number here:
.................................
Dimensions: p. 22-24
Electrical scheme: p. 25-27
EN 21