Siemens SINUMERIK 840D sl Manuel De Mise En Service page 555

; If DisableNATRouting is set to 1, the NCU won't forward from TCU
; or IBN net (X120 and X127, resp.) to external net (X130).
; If set to "X120" or "X127", forwarding will only be disabled
; from that interface.
;DisableNATRouting=1
[IBNInterface]
; Setting EnableDHCPD_IBNNet to 0 suppresses that a DHCP server
; is started on that interface.
;EnableDHCPD_IBNNet=0
; If DisableIBNForwarding is set to 1, the NCU won't do NAT routing
; from IBN network (X127) to system network (X120).
;DisableIBNForwarding=1
; If EnableSysNetToIBNForwarding is set to 1, the NCU forwards
packets
; from X120 to X127. (Please note that the sending host must be able
; to route the packets to the NCU by its own means, the NCU just
; accepts and forwards packets to 192.168.215.x with this setting.)
;EnableSysNetToIBNForwarding=1
[SNMP]
; The following variables define strings which are delivered
; on certain SNMP requests.
; SNMPLocation and SNMPContact are reported for the standard OIDs
; SNMPv2-MIB::sysLocation and SNMPv2-MIB::sysContact, resp.
; SNMPAutLocation and SNMPFunction are used in the Siemens specific
; AUTOMATION-SYSTEM-MIB as
automationSystemIdent.automationLocationTag
; and automationSystemIdent.automationFunctionTag, resp.
SNMPLocation="not specified"
SNMPContact="not specified"
SNMPAutLocation="not specified"
SNMPFunction="not specified"
[LinuxBase]
; Keep size of /var/log/messages around this value (not followed
; exactly for performance reasons)
LogfileLimit=102400
; Protocol/Port pairs to open in the firewall
; (e.g., TCP/5900, UDP/514, ...)
;FirewallOpenPorts=TCP/5900 TCP
Système d'exploitation NCU (IM7)
Manuel de mise en service, 03/2009, 6FC5397-1DP10-4DA0
Configuration du système
2.3 Fichier de configuration "basesys.ini"
25