Limiting Thethermostat Setting Range - Dimplex GFP 050 B Instructions De Montage Et De Service

GB
If the power cord of this heater is damaged, it must be re-
placed.; a suitable new power cord is available from the
manufacturer or the after-sales service.
4. Heating Operation
The heater controls are located
behind a hinged cover on the
right side of the heater top.
The heater is switched on and
off by means of the power switch. The right indicator light (B)
is illuminated when the appliance is switched on.
Lower
temperature
*
Indicator light (A) Indicator light (B)
"Heating On" "Heater On"
4.1 Thermostat
The heater is fitted with an electronic thermostat by means of
which the room temperature can be controlled by choosing a
suitable setting. The ∗ setting corresponds to a room tem-
perature of approx. 6 ° C (frost protection setting) . To increase
the temperature, move the slide switch to the right.
The left indicator light (A) is illuminated when the heater is in
the heating mode.

4.2 Limiting theThermostat Setting Range

The setting range of the thermostat can be defined by means
of the two limiting pins (A) provided on the heater rear panel.
One pin each is provided for limiting the upper and lower
value.
The pins can be removed by moving them back and
forth, e.g. by means of flat nose pliers, and be inserted
into the holes in the thermostat.
A
5. Overheat Protection
The heater is equipped with an overheat protection for your
safety. If the air circulation is impeded, the heater is switched
off by the overheat protection. Once the heater has cooled
sufficiently, it will automatically switch on again.
Higher
temperature
Thermostat
MAX
Power switch
On/Off
In the event that the overheat protection trips repeatedly, the
cause of overheating must be determined, e.g. air grille is
covered or obstructed.
For maximum heat output it is essential that you keep the air
inlet and outlet openings free of dust. Clean the heater with a
vacuum cleaner before the start of the heating season!
6. Malfunctions
If there is no heat output from the unit, please check that the
heater is switched on and that the thermostat is set to the de-
sired temperature. Subsequently check the circuit breaker on
the main service panel, or the fuse, to ensure that they have
not tripped or blown.
When a programming cassette is used check that the pro-
gram "ON" is active (also refer to the operating instructions of
the programming cassettes on the pages that follow).
If the fault cannot be corrected, please consult the nearest
after-sales service agent.
For processing the service call, the product number (E-
number) and the manufacturing date code (FD-number) of
the heater are required. These data can be found on the rat-
ing plate.
Repairs to the appliance, or any other interventions, may only
be performed by a qualified electrician or the after-sales ser-
vice.
7. Customer Service, Spare Parts
Robert Bosch Hausgeräte GmbH
Deutschland
Auftragsannahme
Tel.-Nr. +49 (0) 1801 / 22 33 55
Fax.-Nr. +49 (0) 1801 / 33 53 07
Ersatzteilbestellungen
Tel.-Nr. +49 (0) 1801 / 33 53 04
Fax.-Nr. +49 (0) 1801 / 33 53 08
Email: spareparts@bshg.com
Spare orders via internet: http://www.dimplex.de/en
8. Cleaning
Before cleaning make sure that the heater is disconnected
from the power supply and that it has cooled down. Wipe the
outside of the heater with a soft, damp cloth. Do not use any
abrasive products or furniture polish for cleaning as these
may damage the surface.
Dust that may have accumulated in the heater can be re-
moved from the outside with a vacuum cleaner.
9. Technical Data
Supply voltage
Thermostat
Protection class I
Enclosure type
Type Rated Power
GFP 050 B/W 500 W
GFP 075 B/W 750 W
GFP 100 B/W 1000 W
GFP 150 B/W 1500 W
GFP 200 B/W 2000 W
10. Guarantee
This product is guaranteed for two years in accordance with
our guarantee terms.
Disposal
The appliance should not be disposed of with
household waste, but should be taken to your
local recycling centre.
8
Österreich
Auftragsannahme
Tel.-Nr. 0810 240 260
Fax.-Nr. (01) 60575 51212
Ersatzteilbestellungen
Tel.-Nr. 0810 240 261
Fax.-Nr. (01) 60575 51212
hausgeraete.et@bshg.com
230 V~, 50 Hz
5-30° C
PE conductor
IP X4 (splash-water protected)
Width Height Depth
530 mm 565 mm 107 mm
530 mm 565 mm 107 mm
700 mm 565 mm 107 mm
770 mm 565 mm 107 mm
940 mm 565 mm 107 mm