MZ electronic EV-040 Instructions D'utilisation page 19

Connections
Sensor hole
Recharging the transmitter

Open the cap on the rear of the transmitter, insert the plug of the battery charger making sure
that the reference mark is facing upward. Plug the battery charger into a cigarette lighter to start
charging.

When the charger is switched on the blue LED will light up.
EV-040
6-POLE CONNECTOR
PIN
1 + battery
2 - battery
3 DOWN command
4 UP command
5 Magnetic sensor
6
sensore magnetico
magnetic sensor
4
min.44 mm(1"3/4)
SIGNAL
19
English
Rev. 11 – 2018