Locking/Unlocking - turck PS400 Série Mode D'emploi

9 Indication of the parameter values and programming
Press the "Mode" button. The display now shows the
must be enabled. For this please refer to the information
provided in paragraph 9.1). You can now view the setting
of the parameter "Unit" (see below) or select further
Mode Set
parameters. To select other parameters, press the
Enter
"Mode" button several times. To view the actual
parameter value, simply press the "Set" button for a
short moment.
If you want to alter this value, please press the "Set"
flashing. Via the ⇑ and ⇓ buttons you can now change
Mode Set
the value.
Enter
Then press the recessed "Enter" button to save the
changed value.
The new setting is consequently activated.
Mode Set
Enter
9.1 Locking/Unlocking (disabling/enabling)
This sensor permits inhibiting access to the menu and
programming mode.
To inhibit access, call up the RUN mode, press and hold
Mode Set
the "Mode" and "Set" buttons simultaneously until the
Enter
display indicates Loc.
To enable access, call up the RUN mode, press and hold
the "Mode" and "Set" buttons simultaneously until the
Hans Turck GmbH & Co.KG • D–45466 Mülheim an der Ruhr • www.turck.com
parameter "Unit". (Should "Loc" be displayed, the sensor
button and hold it for 5 s until the shown value stops
display indicates uLoc.
9
/0805