Specifications; Stihl Al 101, Al 300, Al 500; Symbols On The Charger; Engineering Improvements - Stihl AL 101 Notice D'emploi

13 SPECIFICATIONS

13SPECIFICATIONS

13.1 STIHL AL 101, AL 300, AL 500

– Mains voltage: See rating plate
– Rated current: See rating plate
– Frequency: See rating plate
– Charging current: See rating plate
– Rated power: See rating plate
– Insulation: See rating plate
– Permissible ambient temperature range during charging:
41 °F to 104 °F (5 °C to 40 °C)
WARNING
￭ A typical household electrical circuit is between 15 and
20 amps. A single STIHL AL 500 charger draws
approximately 4.8 amps. A single AL 300 draws
approximately 4.4 amps and an AL 101 approximately
1.3 amps. To reduce the risk of fire from overloading an
electrical circuit:
– Ensure the electrical system is rated to withstand the
expected electrical draw before charging your
battery.
– Charge multiple batteries one at a time or on
separate circuits, unless you know your circuit can
handle the total expected draw from multiple
chargers.

13.2 Symbols on the Charger

Symbol Explanation
V Volt
Hz Hertz
A Ampere
W Watt
0458-511-8221-D
Symbol Explanation
AC Alternating current
IP20 Degree of electrical protection
X The power supply cord can be replaced by an
authorized STIHL servicing dealer.
Direct current
Fuse
Read the manual
Insulation: Class II (Double Insulation)
Use and store charger only indoors in dry rooms
Certification/listing mark of CSA
California Energy Commission. This battery system
complies with the California Energy Commission
efficiency requirements.
Manufacturer Code

13.3 Engineering Improvements

STIHL's philosophy is to continually improve all of its
products. As a result, engineering changes and
improvements are made from time to time. Therefore, some
changes, modifications and improvements may not be
covered in this manual. If the operating characteristics or the
appearance of your machine differs from those described in
this manual, please contact your STIHL dealer or the STIHL
distributor for your area for assistance.
13.4 EMC Compliance Statement for Power Tool
and Charger
This Class B digital apparatus complies with Canadian
ICES-003.
English
11