Mounting The Charger On A Wall; Led Diagnostics; Led On The Charger; Transporting - Stihl AL 101 Notice D'emploi

English
7.3

Mounting the Charger on a Wall

When mounting, ensure that no electrical cables, pipes or
other service lines run in the wall behind the charger.
To mount the wall charger:
b
1 2
c
a
► Mount the charger indoors in a dry room near an electrical
outlet.
► Sink the screws into a wall stud. Use appropriate screw-in
wall anchors or other similar mounting devices if an
appropriate wall stud is not available.
► Align the charger as shown above. Mount to a wall with the
following dimensions:
– a = minimum 18 in. (450 mm)
– b = minimum 3.9 in. (100 mm)
– c (for AL 101) = 3.0 in. (75 mm)
– c (for AL 300 and AL 500) = 4.7 in. (120 mm)
– d = 0.2 in. (4,5 mm)
– e = 0.4 in. (9 mm)
– f = 0.1 in. (2,5 mm)

8 LED DIAGNOSTICS

8.1

LED on the Charger

One LED shows the status of the charger. The LED can glow
green or flash red.
8
3
e
d
f
f
For more information, @ 12.

9 TRANSPORTING

9.1

Charger

To properly transport the charger:
► Disconnect the charger from the electrical outlet.
► Remove the battery from the charger.
► Wrap the power supply cord and attach it to the charger.
► When transporting the charger in a vehicle, secure and
position the charger to prevent turnover, impact and
damage.
If the LED glows green continuously: the battery
is being charged.
or
The battery is too hot or too cold for charging. To
determine, check the LEDs on the battery. If
there is one glowing red light, allow the battery to
warm up or cool down gradually at an ambient
temperature of about 50 °F to 68 °F (10 °C to
20 °C).
If the LED flashes red: there is no electric contact
between the battery and the charger. Remove
and reinsert the battery.
or
The battery has a malfunction and must be
replaced. Check the LEDs on the battery. Do not
use or charge a battery if its LEDs indicate a
malfunction.
or
The charger has a malfunction. Have it checked
by an authorized STIHL servicing dealer before
use.
8 LED DIAGNOSTICS
0458-511-8221-D