Handi ® 800; Description; Connections; Impulse Receiver Version - Gorgy Timing HANDI 300 Mode D'emploi

4.1. DESCRIPtIOn

analogue clocks in impulses receiving versions, aFnOR nFs 87500 / iRiG-B 122, DCF,
Radio DHW (869 MHz), or nTP.

4.2. COnnECtIOnS

To reset the clock switch it off and on by the "ON" / "OFF" located on the
rear face of the clock (except the DCF receiving version).
With the waterproof version, open the clock to make the adjustment.

4.2.1. IMPULSE RECEIVER VERSIOn

X 6
► Open the clock by unscrewing the bottom of the
clock.
► Connect the clock to the impulse line as shown
below in the opposite figure.
► To set the time on the clock manually, use the
knob on the back of the movement.

4.2.2. aFnOR nFS 87500 / IRIG-B 122 RECEIVER VERSIOn

► Connect the code aFnOR nFs 87500 / iRiG-B 122 (no polarity).
► Depending on the power supply option, connect the clock to the mains.
► Change the switch position on the outside of the unit onto the "On" position..
☛
The hands are positioned at 12 o'clock and then, after receiving the
code, are positioned according to the received time information.
MDE-HANDI-2078V2.0
X 6
4. hanDI
X 8
1 2 3
B1
min.
800
®
39