Handi 300 & Handi 450; Description; Connections; Standalone Version - Gorgy Timing HANDI 300 Mode D'emploi

2.1. DESCRIPtIOn

analogue clocks in standalone versions or receiving pulses, aFnOR nFs 87500 / iRiG-B 122,
DCF, Radio DHW (869 MHz), Rs485 asCii or nTP.

2.2. COnnECtIOnS

To reset the clock switch it off and on by the "ON" / "OFF" located on the
rear face of the clock (except the DCF receiving version).
With the waterproof version, open the clock to make the adjustment.

2.2.1. StanDaLOnE VERSIOn

► Open the clock by unscrewing the bottom of the
clock.
► set the time, use the wheel on the back of the
movement.
► Close the clock.
► Depending on the power supply option, insert
the batteries in their housing or plug the clock
into the mains.

2.2.2. IMPULSE RECEIVER VERSIOn

► Connect the clock to the impulse line as shown
below in the opposite figure.
► To set the time on the clock manually, use the
knob on the back of the movement.

2.2.3. aFnOR nFS 87500 / IRIG-B 122 RECEIVER VERSIOn

► Connect the aFnOR nFs 87500 / iRiG-B 122 code (no polarity).
► Depending on the power supply option, connect the clock to the mains.
► Change the switch position on the back onto the "On" position.
☛
The hands are positioned at 12 o'clock and then, after receiving the
code, are positioned according to the received time information.
30
Tightening 1.3 n.m maximum.
2. hanDI 300 & hanDI
®
X 6
1 2 3
B1
min.
MDE-HANDI-2078V2.0
450
®