Quick RGBW Manuel D'installation Et D'emploi page 11

DIMMER RGBW - REV005A
OPERATION
LOCAL OPERATION
For local operation, turn DIP switch 4 OFF.
In local operation the unit controls the channels directly through the inputs, in three manners:
Single-colour light
To select this type of light, set Dip-switch 5 and 6 to Off.
The 4 channels work independently and can control single-colour light sources through 4 inputs:
• Briefly press the input button (1-4) to turn on the light of the relative channel at the last light value setting.
• Briefly press the input button (1-4) to turn off the light.
• Press and hold the input button (1-4) to progressively dim and brighten the light and vice versa.
• When you release the button after reaching the desired intensity, the setting is automatically stored.
• Briefly press the button on input 5 to turn on all the channels at 60% intensity.
• Briefly press the button on input 6 to turn off all the channels.
Tunable white light
To select this type of light, set Dip-switch 5 to On and 6 to Off.
The 2 channels (outputs 1 and 2 for channel 1; outputs 3 and 4 for channel 2) work independently and control dynamic
white light sources. Control occurs with inputs 1 and 2 dedicated to channel 1 and inputs 3 and 4 dedicated to channel 2,
as follows:
• Briefly press the input 1 button (3) to turn the light for channel 1 (2) on and off. The level of light intensity and colour
shade are stored.
• Briefly press the input 3 button (4) to turn the light to channel 1 (2) on and off. The level of light intensity and colour
shade are stored.
• Press and hold (>2 sec) the input 1 button (3) to vary the intensity for the light for channel 1 (2).
• When you release the button after reaching the desired intensity, the setting is automatically stored.
• Press and hold (>2 sec) the input 2 button (4) to vary the colour shade for channel 1 (2).
RGBW light
To select this type of light, set Dip-switch 5 and 6 to Off.
The 4 outputs are all used to handle a single source of mixed RGBW (Red, green, blue and white) light.
The controls are available on 4 inputs:
• Briefly press the input 1 button to turn the light on and off. The light intensity and colour settings are stored.
• Press and hold the input 1 button to progressively dim the light up or down and vice versa in the selected colour.
• When you release the input 1 button after reaching the desired intensity, the setting is automatically stored.
• Briefly press the input 2 button to change colour in steps, choosing from red, green, blue, yellow, sky-blue, purple, and
white.
• Briefly press the input 3 button to enable and disable a preset scenario.
• Briefly press the input 4 button to turn the output that controls the white light on and off, excluding the first 3 outputs.
• Press and hold the input 4 button to progressively dim the light up or down and vice versa, on the output that controls the
white light.
QUICK SPA
11
OPERATION
EN