Safety; Installation Requirements; General; Flue - Dovre SAGA 101 Installation Et Mode D'emploi

Safety

Please note: All safety regulations must be
complied with strictly.
Please read carefully the instructions supplied
with the appliance for installation, use and
maintenance before using the appliance.
The appliance must be installed in accord-
ance with the legislation and requirements
applicable in your country.
All local regulations and the regulations
relating to national and European standards
must be observed when installing the appli-
ance.
The appliance should preferably be installed
by an authorised installer. Installers will be
aware of the applicable regulations and
requirements.
The appliance is designed for heating pur-
poses. All surfaces, including the glass and
connecting tube, can become very hot (over
100°C)! When operating, use a so-called 'cold
hand' or an oven glove.
Ensure that the appliance is adequately
guarded if young children, disabled people,
the elderly or animals are present in the
vicinity.
Safety distances from flammable materials
must be strictly adhered to.
Do not place any curtains, clothes, laundry or
other combustible materials on or near the
appliance.
When in use, do not use flammable or
explosive substances in the vicinity of the
appliance.
Avoid chimney fires by having the chimney
swept regularly. Never burn wood with the
door open.
In the event of a chimney fire: close all the
appliance's air inlets and alert the fire service.
If the glass in the appliance is broken or
cracked, it must be replaced before the stove
is used again.
D OVRE
6
Do not exert force on the door, do not allow
children to pull on the opened door, never
stand or sit on the opened door and do not
place heavy objects on the door.
Ensure that there is adequate ventilation in
the room in which the appliance is installed. If
ventilation is insufficient, combustion will be
incomplete, which may lead toxic gases to
spread through the room. See the chapter
'Installation requirements' for more inform-
ation on ventilation.
Installation
requirements

General

The appliance must be connected tightly to a well-
functioning flue.
For connection measurements: see 'Technical
data' appendix.
Ask the fire service and/or your insurance com-
pany about any specific requirements and reg-
ulations.

Flue

The flue is needed for:
Removal of combustion gases via natural
draught.
As the warm air in the flue or chimney is
lighter than the outside air, it rises.
Air intake, needed for the combustion of fuel in the
appliance.
A poorly functioning flue or chimney can cause
smoke to escape into the room when the door is
opened. Damage caused by smoke emissions into
the room is not covered by the warranty.
Do not connect multiple appliances (such as a
boiler for central heating) to the same flue,
unless local or national regulations allow this.
In the event of two connections ensure that
the difference in height between the con-
nections is no less than 200 mm.
Subject to change because of technical improvements