Assa Abloy Emtek CF Mechanism Guide D'installation page 3

5. Install Inside Trim
Lever sets are universal and can be flipped for right or left
handed doors.
Step 1: Mount Pre-Assembled Trim, with the spindle
entering the center of the plastic alignment tool.
!
If this handle set has a privacy function, ensure
that the release hole is on the side closest to the
edge of the door.
Step 2: Place the CF Mechanism with the arrow pointing to
the door edge. Fasten it with (2) machine screws. Check the
trim alignment before fully tightening the screws.
!
Ensure the hole in the CF Mechanism aligns with
the privacy pin hole in the Latch.
Step 3: Fully extend the spindle by pulling it outwards to
ensure it is against the internal stop.
!
It's important to check if the spindle is fully
engaged with the latch. Rotate the lever or knob
until the spindle is retracting the latch. Pull the
spindle again if necessary.
Step 4: After the spindle has been fully extended, tighten
the Pre-installed set screw in the lever or knob with the
provided Allen wrench. Ensure that it is firmly tightened.
Step 5: Insert the short end of Allen wrench into the
spindle and ensure that it is securely tightened.
3