Putting Out Of Operation - Abicor Binzel MFS-V3 Mode D'emploi

M-Drive
1
1 Control lead jack X46
Fig. 14
Masterliner M-Drive control elements – back

8 Putting out of operation

NOTICE
• Please make sure that the shutdown procedures for all components mounted in the welding system are
1 Use the main switch on the eBOX to cut the power to the M-Drive.
 Please see the information in the eBOX operating instructions BAL.0388.0.
2 Inching trigger S7
strictly observed before putting out of operation begins.
8 Putting out of operation
2
3
3 Wire inlet
EN - 19