Synchro-Recording With A Sony Cd Player; (Cd Synchro-Recording) - Sony MDS-PC2 Mode D'emploi

Synchro-recording With a
Sony CD Player

(CD Synchro-recording)

When the deck is connected to a Sony CD player or Hi-Fi
component system, you can easily copy the contents of
CDs to the MD using the deck's remote. As the same
remote operates both the MD deck and the CD player or
CD player section of the component system, make sure to
place the MD deck and the CD player as close together as
possible.
Note
On some CD players and Hi-Fi component systems, you may
find it impossible to perform CD Synchro-recording using the
deck's remote. In this case, use Music Synchro-recording (page
19) to record from CDs to the MD.
Z
DISPLAY
CD-SYNC STOP
H
z
.
m
1
Turn on the amplifier and the CD player, and select
CD on the amplifier.
2
Do steps 2 to 9 of "Recording on an MD" on pages
14 and 15.
3
Insert a CD into the CD player and select the
playback mode (shuffle play, program play, etc.) on
the CD player.
4
Press CD-SYNC STANDBY.
The CD player changes to play standby and the MD
deck changes to recording standby.
5
Press CD-SYNC START.
The deck starts recording and the CD player starts to
play.
The track number and elapsed recording time of the
track appear in the display.
If the CD player doesn't start playing
Some CD players may not respond when you press
CD-SYNC START. Press X on the CD player's remote
to start play on the CD player.
20 GB
` / 1
CD-SYNC START
CD-SYNC STANDBY
+
–
X
x
>
+
M
–
Operations you may want to do during CD
Synchro-recording
To
Stop recording
Pause recording
Resume recording after
pausing
Check the remaining
recordable time on the MD
z
You can use the remote of the CD player during CD Synchro-
recording
Press To change the deck to And change the CD player to
H Recording
x Recording pause
X Recording pause
z
You can select the next track to be recorded using the
remote of the CD player during recording pause
1 Press X to pause recording.
2 Press ./> repeatedly to select a track.
3 Press H to resume recording.
z
During CD Synchro-recording, track numbers are marked in
the following ways:
• When the CD player is connected to the DIGITAL (OPTICAL)
IN1/2 connector, track numbers are automatically marked as
they appear on the CD.
• When the CD player is connected to the LINE (ANALOG) IN
jacks, track numbers are automatically marked when "T.Mark
LSync" has been selected (page 18).
• When you resume recording after recording pause, a new track
number is automatically marked, regardless of the track
marking parameter setting ("T.Mark LSync" or " T.Mark Off").
z
You can change CDs during CD Synchro-recording
1 Press x on the CD player's remote.
2 Change the CD.
3 Press H on the CD player's remote to resume recording.
Press
CD-SYNC STOP
CD-SYNC STANDBY
CD-SYNC START
DISPLAY (page 11)
Play
Stop
Pause