Publicité
• Pass your bare upper arm through
the tube-shaped cuff.
• The cuff must be placed on the
upper arm so that the bottom edge
is positioned 2 – 3 cm above the
elbow and over the artery. The line
should point to the centre of the
palm.
• Now tighten the free end of the
cuff, but make sure that it is not too
tight around the arm and close the
hook-and-loop fastener. The cuff
should be fastened so that two
fingers can fit under the cuff.
• This cuff is suitable for you if the
index mark (
) is within the OK
range after fitting the cuff on the
upper arm.
• Now insert the cuff line into the
connection for the cuff connector.
All manuals and user guides at all-guides.com
Adopting the correct posture
• To carry out a blood pressure measure-
ment, make sure you are sitting upright
and comfortably. Lean back and place
your arm on a surface. Do not cross
your legs. Place your feet next to each
other flat on the floor.
• Always make sure that the cuff is at
heart level.
• To avoid distorting the measurement,
you should remain as still as possible
during the measurement and not
speak.
Performing the blood pressure measurement
• To start the blood pressure monitor, press
the Start/stop button
ments are briefly displayed.
• After the full-screen display, the respective alarm sym-
bols are displayed if alarm
• The blood pressure monitor will begin the measure-
ment automatically after approx. 3 seconds.
• The cuff inflates automatically while the actual measu-
ring process starts. As soon as a pulse is found, the
pulse symbol
26
. All display ele-
/
is activated.
is displayed.
Publicité
