Publicité
TABLE OF CONTENTS
I - INITIAL VERIFICATION
Thank you for choosing a BODET clock. This product has been carefully designed for your
satisfaction based on ISO9001 quality requirements. We advise you to read this manual
thoroughly before attempting to manipulate the clock.
The installation and the maintenance service of this clock has to be done by skilled person.
These
indicate important comments.
Keep this booklet during all the life of your clock, so that you can refer to it each time it is
necessary.
1.1 Unpacking the clock
Unpack with caution and check the contents of the packaging. It must contain :
- The Opalys 7 clock clipped on to its wall holder,
- A 12W 240V/24V power supply,
- A fixation kit (2 screws + 2 rawlplugs),
- A cleaning kit (impregnated antistatic cloth),
- with option, a table holder.
- This booklet..
Remark : when unpacking, some segments of the clock can be activated. This is not
a default, connect the low voltage power supply and after a few seconds the problem
will disappear.
Versions : A descriptive label is fixed to the back of the clock :
RAD DCF = the clock is radio-synchronised by a DCF antenna.
AFNOR/IMP = the clock is receiving (driven by a master clock delivering impulses,
minute or 1/2 minute from 12 to 48V, on a parallel line, or coded time AFNOR NFS-
87500A).
RAD DHF = the clock is radio-synchronised by a DHF transmitter.
Bodet accepts no responsibility for accidents resulting from any use not conforming with
the above provisions.
Any modification to the product will invalidate the warrantee.
1.2 Backup
All the parameters for the clock are saved permanently even in the absence of power.
The clocks keep their time bases during a few days thanks to their internal battery.
All manuals and user guides at all-guides.com
21
Publicité
