WMF LINEO Notice D'utilisation page 10

▪ Once the desired result is achieved, wait until the motor and whisk (13) stop and disconnect the
mains plug.
▪ Loosen the adapter (12) from the drive unit by pressing the unlock button (4). Pull the adapter (12)
away from the whisk (13).
Cleaning and care
Disconnect the mains plug immediately after use.
Always clean the blender (5) immediately after use to prevent dried-on leftovers from damaging the
bearing of the blender (5).
For preliminary cleaning, let the blender run for a short period time in a receptacle containing hot water.
The blender (5) is locked into the appliance during use and can only be removed by pressing the
release button (4). The blender (5) can now be removed.
For safe storage, put the purée rod (5) in the protective cap (6).
Clean the accessory immediately after use so that dried-on residual food cannot damage the accessory.
Do not use any abrasive cleaning agents.
Dishwasher safe
Drive unit
Purée rod (5)
Protective cap (6)
Measuring jug with anti-slip base (7)
Upper part with integrated adapter
(8)
Container (9)
Stainless steel knife (10)
Anti-slip base (11)
Adapter (12)
Whisk (13)
Milk frother (14)
18
Can be rinsed Wipe with a
under running damp cloth
water
Technical data
Voltage: 220–240 V~ 50–60 Hz
Power consumption: 590–700 W
Appliance class: I
Technical information on the operating modes pursuant to EU Regulation 2023/826:
MODE POWER CONSUMPTION (WATT)
OFF
Standby
Standby with additional
information
Networked standby
The appliance complies with European directives 2014/35/EU, 2014/30/EU and 2009/125/EU.
The conformity according to EN60335 clause 11 was verified by using chopper accessory and the fol-
lowing recipe: 210g flour + 100g water + 40g honey
Short Operation Time: 3s; Resting 10 minutes between cycle
For UK use only
▪ This product is supplied with a 13 A plug conforming to BS 1363 fitted to the mains lead. If the
plug is unsuitable for your socket outlets or needs to be replaced, please note the following. If the
plug is a non-rewireable one, cut it from the mains lead and immediately dispose of it. Never insert
it into a socket outlet as there is a very great risk of an electric shock.
▪ The replacement of the plug at the mains lead has to be done according to the following instruc-
tions:
Warning - This appliance must be earthed
Important: The wires in this mains lead are coloured in accordance with the following code:
green/yellow Earth
blue Neutral
brown Live
As the colours of the wires in the mains lead of this appliance may not correspond with the
coloured markings identifying the terminals in your plug, proceed as follows:
⋅ the wire which is coloured green and yellow must be connected to the terminal which is
marked with the letter E or by the earth symbol
⋅
the wire which is coloured blue must be connected to the terminal which is marked the letter
N or coloured black,
⋅
the wire which is coloured brown must be connected to the terminal which is marked with
the letter L or coloured red.
▪ If a 13 A (BS 1363) plug is used it must be fitted with a 13 A fuse conforming to BS 1362 and be
ASTA approved. If any other type of plug is used, the appliance must be protected by a 10 A fuse
either in the plug or adapter or at the distribution board.
If in doubt - consult a qualified electrician.
▪ Never use the plug without closing the fuse cover.
PERIOD (MINUTES)
0.2 –
– –
– –
– –
, or coloured green or green and yellow,
19