Publicité
OPERATION
Chain Lubrication Test
Hold the chain just above a dry
surface and open the throttle to half
speed for 30 seconds.
A thin line of "thrown" oil should be
seen on the dry surface.
Cutting Instructions
General
This chainsaw is designed for cutting wood. Do not cut
metal, plastic or any non-wood material.
Wear suitable hearing
protection such as
earmuffs or earplugs to
protect against
objectionable or
uncomfortable loud
noises.
Do not let the tip of the
bar touch anything while
the engine is running. At
cutting speed the chain is
moving at a high rate of
speed. Should the tip
contact a limb or log while
the chain is moving, the
tip will be pushed upward
with considerable force.
This is known as kickback. Avoid it!
In all circumstances the operation of the chainsaw is a one-man job. It is
difficult at times to take care for your own safety, so don't assume the
responsibility for a helper as well. After you have learned the basic
techniques of using the saw, your best aid will be your own good common
sense.
36
CS-7310P
Kickback
X7503341100
© 02/24 ECHO Incorporated
Publicité
