Publicité
SAFETY
Do not allow the saw to tip forward in order to avoid damage to the
chain.
If the chain does not stop immediately, return the saw to your
authorized dealer for repair.
Note:
• For practice, while cutting a small tree, push the lever forward to lock
the brake.
• Confirm that the brake works properly before each use.
• If the chain brake is clogged with wood chips, function of the brake may
deteriorate. Always keep the device clean.
• Do not increase engine RPM while the chain brake is locked.
Do not use a a bar and chain combination other than those specified in this
manual.
For your own safety, do not remove the chain brake system.
The installation of a chain brake may be mandatory by law or as stipulated
by insurance regulations in your area of operation. You should inquire
through local government offices, your employer or your local dealer to
ensure that your chainsaw conforms to the required safety standard.
Chain brakes have been designed and tested to comply with international
safety standards as follows:
USA: ANSI Standard B175.1 Safety Requirement for chainsaws.
Canada: CSA Standard Z62.1, Z62.3.
ANSI Standard B175.1 and CSA Z62.1.3 stipulate that the brake
shall stop the chain 0.12 seconds at an engine speed of 13,500
r/min. It is the responsibility of the owner/operator to ensure
that the brake is serviced, adjusted and tested strictly in
accordance with the instructions as detailed here in order to
ensure that the brake performance is maintained in compliance
with the Standards B175.1 and CSA Z62.1.3.
14
CS-7310P
X7503341100
© 02/24 ECHO Incorporated
Publicité
