Publicité
wetted parts:
•
PTC thermistor probe: stainless steel
•
Plastic: PA6 (Furkamid B SK 1)
•
Sealing material: 3M Scotch Cast No 815 perm. elast. 2 comp.
•
Cable: Ölflex 100, resistant to acids, lye and oils which are not adhesive
or coking
Any use other than the application explicitly permitted in these operating
instructions is not permitted and causes hazards.
Verify that the product is suitable for the application planned by you prior to
using the product. In doing so, take into account at least the following:
•
All directives, standards and safety regulations applicable at the installa-
tion site of the product
•
All conditions and data specified for the product
• The conditions of the planned application
In addition, perform a risk assessment in view of the planned application,
according to an approved risk assessment method, and implement the
appropriate safety measures, based on the results of the risk assessment.
Take into account the consequences of installing or integrating the product
into a system or a plant.
When using the product, perform all work and all other activities in conjunc-
tion with the product in compliance with the conditions specified in the oper-
ating instructions and on the nameplate, as well as with all directives, stand-
ards and safety regulations applicable at the installation site of the product
2.3
Predictable incorrect application
The product must never be used in the following cases and for the following
purposes:
•
Use as overfill prevention system as per TRbF
•
Hazardous area (EX)
- If the product is operated in hazardous areas, sparks may cause defla-
grations, fires or explosions.
The PTC thermistor probe type 937 must never be used in the following
cases:
•
Use with corrosive media
Information on safety
RG 210
EN
5
Publicité
