Hoshizaki FM-120KE-50-HC Notice D'installation page 6

ENGLISH
4) Remove the front panel (left) and top panel.
5) Remove the protective plastic film from the exterior. If the icemaker is
exposed to the sun or to heat, remove the film after the icemaker cools.
4. LOCATION
This icemaker is not intended for outdoor use.
The icemaker should not be located next to ovens, grills or other high heat producing
equipment.
This appliance is not suitable for installation in an area where a water jet could be used.
The location should provide a firm and level foundation for the icemaker.
Do not place anything on top of the icemaker or in front of the louver.
Normal operating ambient temperature should be within 5°C to 40°C. Water connection is
cold water only. Operation of the icemaker, for extended periods, outside of these normal
temperature ranges may affect production capacity.
Allow the clearance specified below for proper air circulation and ease of maintenance and/or
service should they be required.
Top View
Left
15cm
In some high humidity environments, condensation may form inside the machine and drip onto
the floor. Do not install where the floor can be affected by water.
Avoid prolonged exposure of the appliance to direct sunlight.
5. INSTALLATION
Incorrect installation can cause harm to people, animals or other items, for which the
manufacturer cannot be held responsible.
1) Position the icemaker in the selected permanent site.
WARNING
CAUTION
NOTICE
IMPORTANT
Rear
15cm
Right
15cm
ICEMAKER
Front
CAUTION
Front Panel
(Left)
Top Panel:
Front Panel (Left): Remove the screws. Lift up
Side View
Front
ICEMAKER
4
Top Panel
Remove the screws and lift off.
and pull toward you.
Top
15cm
Rear
15cm