Publicité
INSTALLATION GUIDE
This appliance meets all relevant CE guidelines.
The data plate on the underside of the appliance indicates the total
nominal load, the required voltage and the frequency.
Safety
This appliance should only be connected up by a registered electrical
installer!
The electrical connection must comply with national and local
regulations.
The appliance should always be earthed.
Damage caused by incorrect connection, incorrect use or incorrect
building in is not covered by the guarantee.
For correct operation of the appliance it is important that:
– the power cable hangs freely and is not struck by a drawer;
– the worktop is level.
The walls and the worktop around the appliance must be made of heat-
resistant (>85°C) material. Even if the appliance itself does not get hot,
the heat from a hot frying pan, for instance, could cause discolouring or
damage to the wall or worktop.
94
All manuals and user guides at all-guides.com
general
INSTALLATION GUIDE
Electrical connection
Power setting table
Cut opening in worktop
Table
built in HL40..F/HL40..M
The power supply to the hob is via the oven or the separate operating
panel. Refer to the installation instructions for the oven concerned or the
operating panel.
Type of hob
HL40..F
Cooklight
Electrical connection
230 V - 50 Hz
Power of element
Front left
2300 W
Front left double
Rear left
1200 W
Rear right
2000 W
Front right
1200 W
Saw the opening in the worktop. This should be done very accurately
(see table). Also saw out any partitions that may be present.
The distance from the saw line to the rear wall and/or side wall is
indicated in the table.
Type of hob
Appliance width x depth
575 x 505 mm
614 x 514 mm
Installation height from top of worktop
Cut out dimensions width x depth
560 x 490 mm
Distance from saw line to rear wall
Distance from saw line to side wall
HL40..M
x
x
x
x
2200 / 1000 W
1200 W
2000 W
1200 W
HL40..F
HL40..M
x
x
95
56 mm
44 mm
x
x
50 mm
50 mm
50 mm
70 mm
Publicité
