Important Notices; Service And Maintenance - SPX Radiodetection RD7000+ Guide D'utilisation

Important notices

When reporting any problems to your Radiodetection Dealer or Supplier it is important to
quote the unit serial number and the purchase date.
WARNING! This equipment is NOT approved for use in areas where
hazardous gases may be present.
WARNING! When using the transmitter, switch off the unit and disconnect
cables before removing the battery pack.
Reduce audio level before using the earpiece.
Batteries should be disposed of in accordance with your company's work practice,
and/or any relevant laws or guidelines in your country.
This instrument, or family of instruments, will not be permanently damaged by
reasonable electrostatic discharge and has been tested in accordance with IEC 01-2.
However, in extreme cases temporary malfunction may occur. If this happens, switch
off, wait and switch on again. If the instrument still malfunctions, disconnect the
batteries for five seconds and then reinstall and switch the unit on.
WARNING! The RD7000+ will detect almost all buried conductors
but there are some objects that do not radiate any detectable signal. The
RD7000+, or any other electromagnetic locator, cannot detect these objects
so proceed with caution. There are also some live cables which the RD7000+
will not be able to detect in Power mode. The RD7000+ does not indicate
whether a signal is from a single cable or from several in close proximity.
Copyright statement
Copyright 2011 Radiodetection Ltd - SPX Corporation. All rights reserved.
Radiodetection is a subsidiary of SPX Corporation.
SPX and Radiodetection are trademarks of Radiodetection Ltd. and SPX Corporation.
Due to a policy of continued development, we reserve the right to alter or amend any
published specification without notice.
This document is protected by copyright and may not be copied, reproduced,
transmitted, modified or used, in whole or in part, without the prior written consent of
Radiodetection Ltd.
1
Trademarks
RD7000, RD7000+, RD8000, RD4000, flexitrax, SurveyCERT, StrikeAlert, SideStep and
eCAL are trademarks of Radiodetection Ltd.
The Bluetooth word mark and logos are owned by the Bluetooth SIG, Inc. and any use
of such marks by Radiodetection Ltd is under license.
FCC and Industry Canada statements
This device complies with part 15 of the FCC Rules. Operation is subject to the following
conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired
operation.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment. To comply with
the FCC RD explore compliance requirements, this device and its antenna must not
be co-located or operated in conjunction with any other antenna or transmitter.
Training
Radiodetection provides training services for most Radiodetection products. Our
qualified instructors will train equipment operators or other personnel at your preferred
location or at Radiodetection headquarters. For more information go to:
www.radiodetection.com or contact your local Radiodetection representative.

Service and Maintenance

The locator and transmitter are designed so that they do not require regular calibration.
However, as with all safety equipment, it is recommended that they are serviced at least
once a year either at Radiodetection or an approved repair center.
Radiodetection products, including this user guide, are under continuous development
and are subject to change without notice. Go to: www.radiodetection.com or contact
your local Radiodetection representative for the latest information regarding the
RD7000+ or any Radiodetection product.
1