Publicité
Switching the appliance on
1) Remove the vacuum cleaner from the wall
bracket
. When you are not using the wall
i
bracket
, pull the barrel plug
i
charging socket
3
appliance .
2) Press the On/Off switch
the appliance . The display
tery indicator
with the remaining running
k
time
(timer) and the operating mode
j
(1 Eco/2 Auto/3 Boost) .
Note
►
The appliance always starts in operating
mode 1 Eco after being switched on .
Selecting an operating mode
The appliance has three different operating
modes, each of which differs in terms of suction
power and running time . Press the M
to select the operating mode:
1 Eco
–
For vacuuming hard floors, delicate
carpets and carpeting with low soiling .
–
The appliance consumes less battery
power and the running time is therefore
longer .
–
Running time with fully charged battery
approx . 35 minutes .
2 Auto
–
For vacuuming hard floors and carpeting
with light to medium soiling .
–
The brush speed is automatically adjust-
ed depending on the floor covering to
optimise the running time .
–
Running time with fully charged battery
approx . 20 minutes .
3 Boost
–
For vacuuming hard floors and carpeting
with heavy soiling
–
Due to the high suction power, the best
suction result is achieved with a short
running time .
out of the
q
on the underside of the
to switch on
y
shows the bat-
l
h
button
x
–
Running time with fully charged battery
approx . 10 minutes .
Dismantling the appliance
Suction pipe
♦
To remove the suction pipe
pliance, hold down the suction pipe release
button
and pull the suction pipe
g
the suction opening of the appliance (see
Fig . 11) .
Fig. 11
Floor brush
♦
To remove the floor brush
pipe
, hold down the floor brush release
f
button
and pull the suction pipe
d
floor brush
(see Fig . 12) .
s
Fig. 12
from the ap-
f
off
f
1.
2.
from the suction
s
off the
f
2.
1.
GB │ IE
│
11
■
Publicité
