Publicité
Congratulations on purchasing your TIMEX
these instructions carefully to understand how to operate your
Timex timepiece. For more information, please visit: Timex.com
WATER AND SHOCK RESISTANCE
If your watch is water-resistant, meter marking or (
Water-Resistance Depth
30m/98ft
50m/164ft
100m/328ft
*pounds per square inch absolute
WARNING: TO MAINTAIN WATER-RESISTANCE, DO NOT PRESS ANY
BUTTONS UNDER WATER.
1. Watch is water-resistant only as long as crystal, crown and case
remain intact.
2. Watch is not a diver watch and should not be used for diving.
3. Rinse watch with fresh water after exposure to salt water.
4. Shock-resistance will be indicated on the watch face or
caseback. Watches are designed to pass ISO test for shock-
resistance. However, care should be taken to avoid damaging
the crystal.
OPERATION:
• Press the MODE (A) button will move from time to date
• Press the MODE (A) button again will move from date to
seconds
• Press the MODE (A) button again will move from seconds back
to time
SETTING:
• Press the RESET (B) button twice to enter the setting mode. The
month will be displayed
• Press the MODE (A) button to advance the number to the
correct month
• Press the RESET (B) button again to display the day of the
month
• Press the MODE (A) button to advance the number to the
correct day of the month
• Press the RESET (B) button again to display the hour
• Press the MODE (A) button to advance the number to the
correct hour (A= AM, P= PM)
• Press the RESET (B) button again to display the minutes
• Press the MODE (A) button to advance the number to the
correct minutes
• Press the RESET (B) button again to exit the setting mode
HOW TO ADJUST BRACELET
(Variations of the following bracelet sections apply to all watch
models).
SLIDING CLASP BRACELET
1. Open locking plate.
2. Move clasp to desired bracelet length.
3. Exert pressure while holding locking plate and slide clasp back
and forth until it engages in grooves on underside of bracelet.
4. Press locking plate down until it snaps closed. Clasp can be
damaged if excessive force is used.
MODE (A)
This digital watch will perform the following functions: TIME, DATE, SECONDS
watch. Please read
®
) is indicated
O
p.s.i.a.* Water Pressure Below Surface
60
86
160
RESET (B)
FEATURES:
FOLDOVER CLASP BRACELET
1. Find spring bar that connects bracelet to clasp.
2. Using a pointed tool, push in spring bar and gently twist bracelet
to disengage.
3. Determine wrist size, then insert spring bar in correct bottom
hole.
4. Push down on spring bar, align with top hole and release to lock
in place.
Fig. 1
BRACELET LINK REMOVAL
REMOVING LINKS:
1. Place bracelet upright and insert pointed tool in opening of link.
2. Push pin forcefully in direction of arrow until link is detached
(pins are designed to be difficult to remove).
3. Repeat until desired number of links are removed.
RE-ASSEMBLY:
1. Rejoin bracelet parts.
2. Push pin back into link in opposite direction of arrow.
3. Press pin down securely into bracelet until it is flush.
TIMEX INTERNATIONAL WARRANTY
http://www.timex.com/productWarranty.html
©2024 Timex Group USA, Inc. TIMEX is a registered trademark of
Timex Group USA, Inc. in the US and other countries.
2
ENGLISH 11D-395000-02
Battery: SR521SW
Battery: SR521SW
Fig. 2
Fig. 3
Model: 11D
Model: 11D
Publicité
