Trebs 99242 Mode D'emploi page 31

NEVER TOUCH THE BLADE ITSELF.
CAUTION: Handle the blade assemblies carefully. They are SHARP and may cause injury. DO NOT attempt to remove blades
from cutting assembly.
Wash all parts in warm, soapy water; rinse and dry thoroughly. All parts are top rack dishwasher safe.
Tip: You may wish to clean your blending and chopper cutting assemblies as follows: squirt a small amount of dishwashing
liquid into blender jar or cups and fill halfway with warm water. Attach blade assembly. Run on 1 for 15 seconds. Repeat,
using clean tap water. Carefully disassemble parts and empty blender jar or cups. Rinse and dry all parts thoroughly.
Finally, wipe the motor base clean with a damp cloth to remove any residue, and dry thoroughly. Never submerge the
motor base in water or other liquids, or place in a dishwasher.
Any other servicing should be performed by an authorized service representative.
5. Troubleshooting
Problem:
My blender is not turning on or going
into Standby mode?
The blender stopped running.
The rubber gasket won't come out from
the blade assembly for cleaning.
The blade assembly is hard to remove
after blending.
Unit appears to be leaking
6. Technical information
Rated voltage: 220-240V / 50Hz
Rated current: 1.5A
Rated power input: 350W
Filling capacity: 35oz (1000ml)
Dimensions:
162mm(l) x 140mm (w) x 377mm (h)
Weight (without package): 1.4 kg
7. Service
If you have any further questions about the product after reading this manual, please contact the Trebs customer service:
info@trebs.nl
Telephone number: 0900-TREBSbv (0900-873 27 28), € 1,00 per talk exclusive the regular telephone costs.
Trebs BV
Thermiekstraat 1a, 6361 HB, Nuth, The Netherlands, Email: info@trebs.nl, Internet: www.trebs.nl
Be sure the blade assembly is on the jar or cup correctly. Be sure it is pushed all
the way onto the base.
1. Plug blender into an independent outlet.
2. Make sure blender is securely plugged in.
3. Check the outlet for power; try plugging into a different outlet.
4. Check your home's circuit breaker.
The motor could have overheated. The resettable fuse, which protects the
motor due to overloading, may have been tripped. When this happens, to
reset the appliance unplug the unit and let it cool for a minimum of 15 minutes.
Then, reduce the contents of the blender jar and/or clear any jams. Restart the
unit as noted in the operating directions.
Run under water and tap on the edge of sink upside down to loosen the gasket.
The ingredients cause pressure, and with the air tight seal, pressure builds up
creating a vacuum or a suction effect. This is normal.
1. Check rubber gasket. Make sure it's flush with blender assembly.
2. Make sure rubber gasket is properly in place.
3. Make sure rubber gasket is not damaged.
Solution:
31