Publicité
PROGRAMMING NUMBER PADS ( 0-9 )
Pre-programming allows repetitive cooking procedures to be stored for ease
of use.
Each program can comprise up to three stages, allowing at each independent
control of Stage time and Microwave power level. However, programs must
be used with caution since if the food to cook varies in weight or density then
good results and more importantly adequately cooked food may not be
achieved. Therefore, it is vital that all food prepared for service should be
checked to ensure that core temperatures have been achieved.
Press and hold PROGRAM PAD
1
until a flashing 'P' appears in the
PROGRAM DISPLAY
2
Enter required cooking time by
pressing the TIME SET PADS
(The display colons flash to indi-
cate a time is required).
Only valid times of Minutes and
Seconds will be accepted.
e.g. 1 minute 1 second not 61 secs
Select the power setting press
3
one of the POWER PADS
Convection Heat or Turbo.
The LED within the selected pad
will light.
To save as a single stage program
Press the required number pad
example: stage 1 saved as Program 8
The program details are displayed
momentarily as the program is
saved.
All manuals and user guides at all-guides.com
Note: Model TA1925 power pads shown
To save a multi-stage program
Press the PROGRAM PAD to enter
up to 2 further stages to the
program.
Follow steps 1– 3 for each stage
of cooking and on completing
press the required number pad
to save.
example: stage 1, stage 2, stage 3
saved as Program 8
12
An amount of experimentation
will be required to determine
the correct program for a
particular product.
Check program details on the
flashing display. Settings can
be changed by stepping back
through the program using the
CANCEL BUTTON.
CALL BACK
To review program details
use CALLBACK.
Press and hold CANCEL
until a flashing 'C' appears
in the program display
Press the number pad for the
program you wish to check and
the details will be displayed.
We recommend you keep a
note of program instructions for
future reference
Publicité
