Publicité
To reassemble, allow the rear section of the scooter to rest upside down on the anti-tip wheels. Lift the front
section by the seat post towards the rear and place the 'ears' on either side of the frame over the main tube of
the rear section as shown below. The front section can now be gently lowered into position.
Once lowered, press down on the seat post and you will hear the front and rear section click into place.
To ensure a secure connection, pull on the seat post to ensure that the rear section is correctly connected.
Rear frame main tube
USE
Clutch release / Freewheel operation:
The clutch release lever is located on the right rear of the scooter. This lever allows you to disengage the drive
mechanism and push the scooter into "freewheel" mode. To disengage the drive, push the lever forwards until
you reach the stop position (indicated by direction 'N').
Simply push the lever towards the rear of the scooter to re-engage the drive (position 'D'.) The scooter will not
operate when the lever is in the disengaged position. The scooter must be switched off and on using the key
switch to reset the circuits before normal operation can be resumed. The scooter will beep continuously if the
brake is disengaged when it is switched on.
Version Février 2024
Front frame lugs
Page 22 sur 43
Publicité
