Publicité
- Get on or off the scooter with the power off.
- Cut the power supply while driving - the scooter will stop abruptly (see emergency procedures).
- Use the scooter where you can walk safely.
- Attempt to walk up or down kerbs.
- Use the scooter if you are under the influence of alcohol or any other medication that may affect lucidity.
- Use a mobile phone while driving.
- Try to negotiate steps or escalators.
- Remain on the scooter while it is being transported in a vehicle.
- Attempt to tow any other device.
- Exceed the stated weight limit.
- Connect any other device to the batteries, as this could cause permanent damage and invalidate your warranty.
- Use batteries/chargers other than those supplied by the manufacturer.
- Travelling on water or soft ground (mud, sand, etc.)
- Lifting the scooter by the bonnet or any other plastic part.
- Shifting your centre of gravity significantly, as this could cause the scooter to become unstable.
- Freewheel on hills. This will damage the motor and brake and invalidate the warranty,
- Tow the scooter with any other vehicle in the event of a breakdown.
Everything has been done to ensure that your scooter provides you with a safe and reliable service, provided
that you follow the advice given above.
ASSEMBLY AND ADJUSTMENT
ASSEMBLY
Before using your scooter, you need to install the handlebar
and seatpost.
To fit the handlebar, you will need the handgrip and spring. Fit
the handgrip through the right-hand hinge.
Position the spring on the screw. Align the two hinge joints and
place the handle thread in the right-hand side of the hinge.
Adjust the handle to the desired angle and tighten the handle
fully.
There
are
two
electrical
connections - white and black
plugs. These must be connected
to the corresponding coloured
connector.
Once
connected,
carefully push the connectors one
by one through the hole
hole in the chassis cover and
insert the eyelet.
To fit the seat post, the rear of the scooter must be removed to gain access to the fixing bolt. Locate the seat
post and align the holes in the frame and upright at the desired height. Tighten the bolt using the Allen key and
the spanner supplied. Refit the rear of the scooter.
For transport, isolate the battery by removing the fuse. It must be replaced before use. The scooter will not
operate until this fuse is fitted. The fuse is packed in the small polythene bag with the tools and the seat post
bolt.
The fuse must be installed in the fuse holder located behind the charging socket cover at the front of the battery
pack.
Version Février 2024
Page 18 sur 43
Publicité
