Publicité
Handlebar control panel :
A - Battery gauge
This gauge indicates the approximate level of charge remaining in the scooter's batteries. The measurement will
be more accurate when the scooter is in motion. Always fully charge the batteries before driving your scooter
and never allow the batteries to discharge completely as this could permanently damage the batteries.
B - Horn
The button activates the scooter's horn. This should only be used to warn others of your presence and not as
a reprimand of any kind.
C - Maximum speed button
The speed control allows you to set the maximum speed of the scooter. Turn clockwise to increase the maximum
speed and anticlockwise to decrease it. Always start at a low speed until you get used to the characteristics of
your scooter. When driving in pedestrian areas such as shopping areas and busy pavements, always respect
other pedestrians and reduce the maximum speed so that the scooter moves at the walking speed of others
around you.
D - Start/Stop button
The key switch is located on the top of the body. Simply insert the key and turn it clockwise to switch on the
device. The display lights up to indicate that power is on. The electronic controller checks the scooter's circuits,
so there may be a slight delay before the levers are operational. Remove the ignition key when leaving the
scooter parked to prevent unauthorised use. Do not turn off the power to stop the scooter unless it is an
emergency. The scooter will stop very suddenly if stopped in this way.
E - Front lighting
This button is used to switch on the LED headlight.
DISASSEMBLY AND REASSEMBLY
The scooter can be quickly and easily dismantled for transport. Always remove the seat and battery before
attempting to dismantle the scooter.
Lift the front of the scooter by the seat post while pulling up on the release lever indicated by the arrow below.
The scooter will now be in two parts.
Version Février 2024
Page 21 sur 43
Publicité
