Publicité
FOR USER
13.2. Parameter Checking
(3) Press
and
code "P0" and the parameter value "0" or "1" will display on the screen, such as "P0
"P0
1".
(4) In "Parameter checking" status, press
13.3. Parameter modification
In "Parameter checking" status, press
or
to change the values, then press
mode. press
13.4. Parameter list
NO.
P0
Heating function
P1
Fan running mode
Compressor continuously running time before
P2
defrosting mode
P3
Defrosting start temp
P4
Defrosting running time
C4
Evaporation coil temp
C5
Gas return temp
C6
Cooling plate temp
C8
EEV opening
C9
DC fan speed
for 5 seconds to enter into "Parameter Checking" status, the parameter
to quit "Parameter Checking" status.
Content
or
to check the parameters.
to enter the "parameter modification" mode, press
to confirm and quit "parameter modification"
Adjust range
0 — no / 1 — yes
0: Reach temp/humidity to low
1: Reach temp/humidity stop
20 ~ 90min
10
°C
°C
°C
P
r/min
speed
-10 ~ 10°C
1 ~ 12min
0" or
Step length
1
1
1min
1°C
1min
Publicité
