SilverCrest SWLB 1200 A1 Instructions D'utilisation Et Consignes De Sécurité page 23

5. Work through the strands section by section
until all the hair finished.
˜ Troubleshooting
Problem
The product is not working.
The product is not sufficiently
heated up.
˜ Cleaning and care
˜ Cleaning
m WARNING! Risk of electric shock!
Always remove the mains plug
mains socket before cleaning the product.
Do not immerse the product in water or other
liquids to clean it.
WARNING! Risk of injury! Allow the
m
product to cool sufficiently before cleaning it.
m NOTICE! Risk of property damage!
Do not use any aggressive cleaning liquids
or solvents. These can damage the surface of
the product.
If any hair gets caught in the Soft bristle
o
Hard bristle and Hot air outlet
[ 2 ]
product: Let the product cool down. Remove
the hair carefully with your fingers.
Clean the product with a slightly damp cloth.
o
For stubborn soiling, wipe the product with a
light detergent on the cloth.
Allow the product to dry fully before using it
o
again or storing it.
˜ Storage
m WARNING! Risk of burns! Allow the
product to cool down sufficiently before
storing it.
For short term storage: Hang the product up
o
by the hanging loop
Store the product in the original packaging
o
when it is not in use.
Cause
The mains plug
inserted into a mains socket.
The mains socket is defective.
The set temperature is too low.
from the
8 ] [
,
[ 1 ]
of the
3 ] [
.
[ 7 ]
6. After use: Switch off the product. Disconnect
the mains plug
Solution
Plug in the product.
is not
[ 8 ]
Try a different mains socket.
Set a higher temperature mode.
Do not press soft bristle
o
by anything when storing.
2 ] [
Store the product in a cool, dry place,
o
protected from moisture and out of the reach
of children.
˜ Disposal
The packaging is made of environmentally
friendly materials, which may be disposed of
through your local recycling facilities.
Observe the marking of the packaging
materials for waste separation, which
are marked with abbreviations (a)
and numbers (b) with following
meaning: 1–7: plastics/20–22: paper
and fibreboard/80–98: composite
materials.
Product:
The product incl. accessories, manual and
packaging materials are recyclable and are
subject to extended producer responsibility.
Dispose them separately, following the illustrated
Info-tri (sorting information), for better waste
treatment.
The Triman logo is valid in France only.
from the mains socket.
8 ] [
and hard bristle
1 ] [
GB/IE 21