SilverCrest SWLB 1200 A1 Instructions D'utilisation Et Consignes De Sécurité page 21

exceeding 30 mA is advisable
in the electrical circuit supplying
the bathroom. Ask your installer
for advice.
m WARNING! Risk of
injury! Use this product
solely in accordance with these
instructions. Do not attempt to
modify the product in any way.
The product is not to be used if
it has been dropped and there
are visible signs of damage.
Disconnect the product from the
power supply and contact your
retailer if it is damaged.
m DANGER! Risk of electric
shock! Never attempt to
repair the product yourself. In
case of malfunction, repairs are
to be conducted by qualified
personnel only.
m WARNING! Risk of
electric shock! Do not
immerse the product in water
or other liquids. Never hold the
product under running water. If
liquid does get into the housing,
disconnect the product from the
power supply immediately and
have the product repaired by a
qualified technician.
Clean all parts of the product
as described in the chapter
"Cleaning and care".
Before connecting the
product to the power supply
socket, check that the voltage
corresponds with the power
supply details shown on the
product's rating label.
Do not use the product
outdoors.
Do not operate the product with
wet hands or while standing on
a wet floor.
Do not touch the power plug
with wet hands.
Do not pull the power plug out
of the power supply socket by
the power cable.
Please switch off the product
before cleaning and
disconnecting the product from
the power socket.
Disconnect the product from the
power supply immediately after
use. The product is completely
free of electrical power only
when unplugged.
Do not kink or crush the power
cable, and route the cable so
that it cannot be stepped on or
tripped over.
Protect the product and power
cable/plug against heat, dust,
direct sunlight, dripping and
splashing water.
GB/IE 19