SilverCrest SWLB 1200 A1 Instructions D'utilisation Et Consignes De Sécurité page 22

Never place the product on
table when it is heating up or
cooling down.
Do not use or store the product
in or expose it to a humid
environment.
˜ Before first use
m DANGER! Do not allow children to play
with packaging materials. There is a risk
of suffocation.
Remove all packaging material and check if
o
all parts are complete.
Clean all parts of the product as described in
o
the chapter "Cleaning and care".
NOTE: The product may give off some odour
during first use. This is due to production or
transport residues that will quickly subside.
Ensure sufficient ventilation in the area.
˜ Operation
˜ Product set up
m WARNING! Risk of burns! The product
becomes very hot during use. Never touch
the Soft bristle , Hard bristle
[ 1 ]
air outlet when the product is switched on
[ 3 ]
and cooling down. Always hold the product
by its handle .
[ 5 ]
Never place the switched-on/hot product on
a table.
Never block the air inlet
1. Connect the mains plug
mains socket.
2. Turn on the product by slide the function
switch to desire function. (see selecting
4 ] [
function)
3. Turn off the product by slide the function
switch to 0 position.
4 ] [
4. After use: Disconnect the mains plug
the mains socket. Allow the product to cool
down completely.
20 GB/IE
and Hot
2 ] [
and air outlet .
6 ] [ 3 ] [
to a suitable
8 ] [
from
8 ] [
Selecting function
Switch Function
Position mode
0 Off
Cool setting
I Low heat/
speed setting
II High heat/
speed setting
Ionization function
Ion reduces the static loading of the hair and
improves its stylability.
The product generate ion and applies to hair
automatically when product switch on. The
product stops generate ion when product switches
off.
˜ Hair styling (Fig. B)
m WARNING! Risk of injury! Make sure
that the hot air outlet
scalp or other parts of your skin.
NOTES:
The hair extended contact with or very
o
frequent heat treating can be damaged.
The hair should be clean and free of styling
o
products.
Hair too wet is not recommended, please dry
o
the hair to slightly dry before styling.
1. Before styling: Use a comb to thoroughly
comb the dry hair.
2. Switch on the product and set the desired
function.
3. Put an approximately 4 cm wide strand of
hair and hold it at bristle. If necessary, short
hold the cool tip
9 ] [
styling.
4. Guide the product evenly along the strand
from close to the root to the tip. Do not hold
the product too long on any part of the hair
strand. Repeat the steps until the result is
satisfactory.
Recommended
for styling
Switch off
Set the style for
longer lasting results
after drying & styling
Styling on hair
begins dry
Initial drying
does not touch your
3 ] [
to rotate the product for