Publicité
All manuals and user guides at all-guides.com
RADIOCONTROL
By mean of the radiocontrol you can effect all working operations of the appliance. In case of
loss or breakdown of the radiocontrol, the appliance can be utilized, with some limitations,
with the emergency controlboard, which is place on the lh back side of the appliance itself. If
the radiocontrol is not available, the appliance continues working with the previously setted
values (room temp., boiler temp., sanitary water temp.), while the room temperature is
realised by the room feeler, which is placed on the appliance. The emergency controlboard
allows to switch ON and OFF the appliance and to set exclusively only 2 levels of power:
LOW power, push button 1, light switched on, next to button 1
HIGH power, push button 2, light switched on, next to button 2
RADIOCONTROL MENU
-Push on button 7 to have access to the menu
-Use buttons 4 and 5 to run on the different menu
-Push again on button 7 to enter into the displied menu
-Use buttons 4 and 5 to run on the different submenu, the button 1 and 2 to modify the value
shown on the display
-The button 7 (menu) accedes to the displayed menu/submenu
-The button 3 returns always to the previous menu
MENU description
Menu 01 SET CLOCK (setting up the clock inside the appliance).
•
Menu 02 SET CHRONO (setting up the programmation for automatic switching
•
ON and OFF).
Menu 03 SELECT LANGUAGE (setting up the language of the radiocontrol).
•
Menu 04 SELECT FEELER (selecting room feeler).
•
Menu 05 STATUS STAND-BY (activates/disactivates Stand-By modality)
•
Menu 06 STATUS BUZZER (setting up of buzzer sound).
•
Menu 07 LOAD INITIAL (continuos fuel load setting).
•
Menu 08 STATUS STOVE (shows the working status of the appliance).
•
Menu 09 PELLET CORRECT (correction of carburation of the appliance).
•
Menu 10 SETTINGS TECHNIC (reserved to TECHNICIANS).
•
MENU 01 (clock setting)
Within this Menu you can adjust the time and the date of the electronic card, the set date and
time will be utilized as reference for the activation of the switch ON/OFF programs.
MENU02 (crono setting)
Within this Menu you can set up the automatic cycles of switching ON/OFF you desire to
utilize. There are 3 different modalities you can utilize, even contemporaneuosly, but pay
attention to not overlap the programmations.
IT IT IT IT- - - - GB
GB- - - - FR
FR mod. 698 TPC– 698 TP-SAC
GB
GB
FR
FR
62/116
Publicité
