Publicité
All manuals and user guides at all-guides.com
STARTING CYCLE
1st Lighting (new stove and whenever the pellet container has been completely emptied
-Put the fuel into the container and switch on the appliance
-In case the display is signalling an alarm keep the push button 3 pressed
-In case the display is signalling "Final cleaning" wait until on the display
appears "Off" (approx. 15 minutes)
-Appliance in switched off condition display "OFF"
-Press on push button 7 (menu) to get access to the programmation menu.
-Press on push button 5 to go on MENU 07
-Press on push button 1 to activate the continuous charge of fuel.
- Once the pellet has started to fall into the burner basket
press on push button 3 to stop the fall of fuel into the
burner basket.
-Empty the burner basket from the fuel and put it again in its correct place.
-Press the push button 3 and keep it pressed for few seconds until the display
reports the start of the lighting.
NORMAL STARTING CYCLE
Press the push button 3 and keep it pressed for few seconds
The appliance begins an automatic cycle to effect the lighting, this cycle is composed by 3
phases, which are shown on the display of the radiocontrol:
1-START (duration approx. 2min.)
(lighting element heating)
3-FLAME LIGHT (duration 5 min)
(burner stabilization)
IT IT IT IT- - - - GB
GB- - - - FR
GB
GB
2-LOAD PELLET (max. duration 18/20 min)
(fuel loading)
Once the lighting phase has been completed,
the appliance starts working normally
59/116
FR mod. 698 TPC– 698 TP-SAC
FR
FR
Publicité
