Publicité
All manuals and user guides at all-guides.com
INSTALLATION
SECTION DESTINATED TO THE INSTALLER
Prescriptions and norms
Read carefully the contents of this handbook, it contains important information and
•
instructions for installation, use, maintenance and product safety.
The installation, the electrical as well as the hydraulic connection, the working
•
verification and the maintenance operations must be carried out by a qualified staff only,
utilizing always the individual security devices and all other security features foreseen by
local laws.
The appliance must be installed inside an room considered suitable for installation and
•
use by competent authorities. All laws, standards and regulations in force on the
installation site must be observed, especially regarding fire prevention.
Technological connection and appliance installation must be carried out by a qualified
•
staff, who is authorized to release a conformity certificate according with the normative
in force and current standards.
All the normative concerning civil town planning and/or industrial in force must be
•
respected inside the installation room of the appliance.
All laws, standards and regulations in force on the installation site must be observed,
•
regarding: flues, electricity, water and steam, drains and waste disposal,
The appliance should be connected to an electrical plant suitable with the declared
•
electrical power of the appliance itself (see data plate).
The manufacturer disclaims all responsibility caused by uncorrect installation,
•
using, tampering, maintenance or no respect of normative in force.
In order to avoid problems arising from residuals and/or deposit it is deeply
•
recommended to effect a complete washing of the plant (specially by new plants) before
connecting the appliance.
Cut-off cocks must be installed out of the appliance, which permits to insulate the stove
•
in case the thermal plant should be disconnected for maintenance and/or repair purposes.
Flexible tubes are preferred to connect the appliance to the plant.
•
Verify that the thermal plant is suitable with declared power of the appliance. The values
•
are reported on the technical data plate, which is placed on the appliance, a copy of it is
attached in this manual.
The connection of the appliance to the thermal plant should also
•
foresee a cock for the emptying of the boiler. This cock should be
placed on the backflow tube and, if possible, connected to the a sink.
The filling of the boiler and eventually of the heating plant must be
•
carried out by qualified technicians, it is possible to control the
pressure of the boiler on the radiocontrol, only after having connected the appliance to
the electric socket. press button 2 to see the pressure.
IT IT IT IT- - - - GB
GB- - - - FR
FR mod. 698 TPC– 698 TP-SAC
GB
GB
FR
FR
41/116
Publicité
