Publicité
LI
_
DOOR REVERSAL
(OPTIONAL)
The following instructions are for models with a round-shaped
door. For models with a square shaped door, an additional kit is
needed. Please contact your retailer, or see "For Assistance or
Service" in your Use and Care Guide.
Tools needed:
=p
S
=
Min. 8" long Torx® T25
#2 Phillips screwdriver
screwdriver
f
'1. Remove door from dryer
Using a Torx® T25 screwdriver, remove the 4 screws securing
the door hinge to the dryer and lift up and out to remove the
door. Place the door on a soft towel or other non-scratch
surface. Reinstall the 4 screws in the holes.
ft ® TORX is a registered trademark of Acument Intellectual Properties, LLC.
16
(
2. Move the door strike
Using a Torx®! T25 screwdriver, remove the 2 screws securing
the
door strike to the door frame of the dryer. Rotate the
strike 180° and attach to the opposite side of dryer door
frame, as shown.
(
3. Remove inner door from outer door
Position the door with the inside of the door facing up.
Using a Phillips screwdriver, remove the 10 screws securing
the inner door to the outer door. Lift off the inner door and
set aside.
Publicité
