Publicité
Install Vent System
1 » Install exhaust hood
12" min.
(305 mm)
install exhaust hood and use caulking compound to seal
exterior wall opening around exhaust hood.
(¢
2.
Connect vent to exhaust hood
Vent must fit over the exhaust hood. Secure vent to exhaust
hood with 4" (102 mm) clamp. Run vent to dryer location using
straightest path possible. Avoid 90° turns. Use clamps to seal
ail joints. Do not use duct tape, screws, or other fastening
devices that extend into interior of vent to secure vent,
because they can catch lint.
12
CONNECT INLET HOSE
The dryer must be connected to the cold water faucet using
the new inlet hoses. Do not use old hoses.
1. Turn cold water off, remove and
replace rubber washer
Check and see if rubber washer is in the "Y" connector.
Remove old rubber washer from inlet hose and replace with
new rubber washer provided.
7
2. Attach short hose and
"¥" connector
lf space permits, attach the brass female end of the "Y"
connector to the cold water faucet. See figure A.
if "Y" connector cannot be attached directly to the cold water
faucet, the short hose must be used. See figure B. Attach
short hose to cold water faucet. Screw on coupling by hand
until it is seated on faucet. Then attach "Y" connector to
brass male end of the short hose. Screw on coupling by hand
until it is seated on connector.
Publicité
